Small Parts 1955-1960 IHC NP201

QU50162 3/8"  Deep Cup NP205 Case Access Soft Plug for the shift fork pin and interlock holes in early production NP205 cases. QU50162 Steel Plug is a USA made deep cup soft plug that is an essential part when rebuilding New Process NP200, NP201,...

QK2036 New Process Transfer Case Shaft Nut and Washer Set replaces worn or damaged New Process Gear (NPG) NP203 and NP205 32 spline output/remote input or idler shaft hardware. Kit includes Hardened Washer and Special USA made Tri-Lobe original equipment...

TKA2053 9 Piece Idler Gear and Output Shaft Shim Kit contains an assortment of shims from 0.004" to 0.040" for precise adjustment of your New Process NP205, NP200, or NP201 gear drive Transfer Case Idler Gear end-play. Also used on NP200 and NP201 rear...

QU20132 New Process Transfer Case Shift Poppet Plug (Poppet Screw) fits New Process NP205, NP200 and NP201 gear drive transfer cases and NP203 full time transfer case. Two of these Plugs or one Plug and one switch are used on dual range New Process...

QU10504 NP200, NP201, NP202, NP203, NP205 Transfer Case Shaft Lock Nut  is a USA Made, 7/8" Extra Fine Thread, Low-Profile, OE Spec Hex Lock Nut for Threaded Output, Counter Shaft, or Remote Input shafts on New Process NP200, NP201, NP202, NP203,...

QU50252 Poppet Spring for New Process NP200, NP201, NP203, NP205 Transfer Cases Two of these Springs are used on all New Process NP200, NP201, and NP205 gear drive Transfer Cases. One spring tensions the Differential Lock Shift Rail on all...

QU50416 Bearing Snap Ring for NP200, NP201, NP205 output and Small Bore Input Ball Bearings. Fits in the outside groove in standard-size bearings such as our TK50105 and TK50119. These Snap Rings are replacements for lost or damaged bearing to case rings...

QU10988 0.010" Thickness Idler  Gear or Rear Shaft Shim for New Process NP205, NP200, and NP201. Individual shim may vary up to 15% from the normal thickness. Precision stamped and de-burred shims have the correct ID/OD to clear the idler shaft and...

QU50185 Set of 16 Transfer Case Rollers Use for Low Gear Rollers in NP205 or as Rear Output Shaft Rollers for NP200, NP201, NP202 Transfer Cases QU50185 Needle Rollers are original equipment quality for maximum durability. NP200 Uses 2 Sets, NP201 and...

QU50351 NPG Transfer Case Rear Output Shaft Pilot Bearing Lock Ring retains the rear output shaft pilot needle roller bearings in New Process NP200, NP201, and NP205 transfer cases. Need More Info? Use the handy Links below to access over 40 years of...

QU10608 0.015" Thickness Idler  Gear or Rear Shaft Shim for New Process NP205, NP200, and NP201. Individual shim may vary up to 15% from the normal thickness. Precision stamped and de-burred shims have the correct ID/OD to clear the idler shaft and...

QU20132U Good Used New Process Transfer Case Shift Poppet Plug (Poppet Screw) fits New Process NP205, NP200 and NP201 gear drive transfer cases and NP203 full time transfer case. Two of these Plugs or one Plug and one switch are used on dual range New...