Wheel Bearing and Hub Tools

QT1833 Outer Rear Wheel Bearing Cup Installer for GM & RAM 3500 trucks with AAM 12" Rear Axles and 2-1/2" Spindle Ends Is a USA Made High-Strength Steel Bearing Cup Installer specifically made to install 100mm OD metric bearing cups used on 2019...

QT1834 Wheel Bearing Cup Installer for 110mm Outside Diameter Bearing Cups. This USA Made Bearing Cup Installer is specifically made to install the 110mm metric wheel bearing cups used on many Dual Rear Wheel rear axles. Common applications include...

QT1264 Ford Dana M275 and Sterling 10.5" SRW Aluminum Rear Hub Support is used with rear wheel hubs that have protruding ABS Tone Rings or Wheel Studs that extend past the end of the hub. This USA Made solid aluminum tool protects your ABS Tone Ring...

QT1266 Rear Wheel Hub to Spindle Alignment Tool for 2" Spindles is a USA Made special hub service tool specific to 2003-current Dodge Ram 2500, Ram 3500 AAM 10.5", 11.5" and 12"  Rear Axles with 2" spindle threads, however it will work on any 2"...

QT1267 Rear Wheel Hub to Spindle Alignment Tool for 2-1/2" Spindles is a USA Made special hub service tool specific to 2019-current  Ram 3500 dually pickups with the High Output Cummins Engine, Ram 4500 and Ram 5500 trucks. These Ram Heavy-Duty...

QT1825 Front Wheel Bearing Installer Tool for 1974-1979 Dodge Dana 44 Live Spindle Front Axles. Use with Shop Press or 5/8" Press Screw.

TS8369 Rear Wheel Tool Set for 1994-2002 with Single Rear Wheels.

QT1106 2" Spindle Thrust Plate can be used in conjunction with a suitable puller to remove a stuck wheel hub or seal ring from almost any 2" diameter full-floating axle spindle if the hub will not pull off by hand. Spindle Thrust Plate is machined by...

QT1179 Economy Bearing Cup Remover Punch is specifically made for the Do-it Yourself mechanic that needs a good, functional, yet lower cost Bearing Cup Removal Punch for occasional use. Our USA Made QT1179 is about 14" long making it long enough to...

QT9301 5/8" x 20" Pro Quality Bearing Cup Remover Punch  has special flattened tip to remove wheel hub, transmission, & pinion bearing cups without damaging the bearing bores. We also use it to remove bearing cups from transfer case idler shafts...