Shift Parts 1998-2002 NP241DLD

QU10164 NPG and NVG Transfer Case Shift Fork Tip Pad fit the tips of many New Process and New Venture transfer case cast iron and stamped steel shift forks. These genuine, original equipment New Process Gear pads are tough and durable and will stay...

QU10589 Dodge Transfer Case Shift Linkage Grommet for either end of many 1980-2002 Dodge transfer case shift rods that connect your floor-mounted shift lever with the transfer case. Genuine original equipment New Process Gear replacement part. Requires 2...

QU11061 Vacuum Supply Line Harness for 1998-2002 Dodge Ram with CAD is a genuine original equipment vacuum harness that runs from the engine back to the transfer case vacuum switch and then down to the transmission cross member on 1998-2002 era Dodge...

QU50078 New Process NP231, NP241 Transfer Case Aluminum Range Shift Fork Aluminum Range Fork with molded shift fork pads is a genuine New Process part that fits many New Process/New Venture NP231, NP241 chain drive transfer cases in mid 1990's and newer...

QU10574 NP241 Transfer Case Mode Fork Center Pad fits all 1994-2002 Dodge NP241 series Transfer Case Range Forks. Imported. Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get...

QU11062 Cross Member to Front Axle Vacuum Line Harness for 1994-2002 Dodge Ram 4x4s with CAD is a genuine original equipment vacuum harness that runs from the transmission cross member forward to the front axle on 1994-2002 era Dodge Ram 4x4s with vacuum...

QU10825 Sector Shaft Inner O-Ring seals the Sector (Shift Cam) Shaft to keep oil in and water out. Fits many models of New Process chain drive, mechanical shift transfer cases. Use in conjunction with QU10824 Outer Seal Ring. Imported. Need More Info? ...

QU95047 3/8" Grade 8 180,000 PST SAE Flat Washer Inside Diameter: 25/64" Outside Diameter: 13/16", Thickness: 0.086" +/- 0.007". Fits between shift lever and QU95035 nut on Dodge and GM NP241 transfer cases. Need More Info? Use the handy Links...

QU50152 Range Slider Shift Hub with 2-way Input Side Clutch Teeth for many New Process NP231 and NP241 series Transfer Cases. This genuine New Process original equipment part will directly replace your worn or chewed up slider. USA Made. Also See:...

QU10929 Mode Fork and Rod (no pads) for all 1994-2002 Dodge Ram trucks with either NP241DLD or NP241DHD transfer cases. Also fits Dodge NP231D series transfer case from 1997-2001. Genuine USA made original equipment New Process Cast Iron Mode Fork with...

QU11050 Transfer Case Indicator Switch is a genuine original equipment Indicator Switch for Dodge and Jeep New Process chain drive transfer cases. QU11050 screws into the front case half, above the internal shift cam on many Jeep and Dodge 4x4s WITHOUT...

QU10629 Mode Fork Spring Plate (Spring Cup) fits between the mode shift fork spring and rear case half on many New Process and New Venture transfer cases. Fits on QU10628 Spring. Also See: QU10629U Used Mode Fork Spring Plate available while...