TK42092 Right 23 Spline Inner Axle Shaft for 1958-1968 W300 Dana 70

TK42092 Torque King® Forged Chrome-Moly 23 Spline Dana 70 Right Inner Axle Shaft for 1958-1968 Dodge W300 4x4 1 ton trucks with Dana 70 Closed Knuckle front axles is a Heavy-Duty, Thru-Hardened Chromoly Inner Axle Shaft forged from American steel. Length about 18-1/8". USA Made. NOTE: To use TK42092, you MUST also order optional TK42172 Special Heavy-Duty Spindle Bushing to install in the end of the axle housing in place of your original bushing.

Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your vehicle's repair, maintenance, or upgrade project!

Dan the Gear Man® Tech Notes:
1969-1974 Dodge Tracta Joints
Dodge MUST Replace Assembly
U-Joints
Matching Parts
Applications

Tech Note 1: 1958-1974 Dodge Tracta Joint
To fit through the spindle hole in the knuckle, 1969-1974 Dodge W300 4x4s were factory equipped with relatively weak Tracta type axle shaft assemblies which are out of production. You can replace the Tracta type axle shaft assemblies with our stronger Chromoly Spicer type 1480WJ Axle Shafts similar in design to the factory shafts used in 1961-1975 IHC Dana 70 Axles and 1967-1969 Jeep Dana 60 Front Axles. The yoke diameter of these shafts is too large to fit through the spindle hole in your knuckle, so to install/remove our axle shaft assemblies, you HAVE to remove the steering knuckle!

Tech Note 2: Dodge-Must Replace Assembly
If you are replacing Tracta Type Axle shafts in 1958-1974 Dodge W300 4x4s, You have to replace the entire shaft which means you are replacing the Inner Shaft, Outer Shaft, and Axle U-Joint.

Tech Note 3: U-Joints
Dana has discontinued the hot-forged, seal-less, solid cross axle shaft u-joints for this application. All our current u-joints have seals which I recommend you remove so lubricant from the knuckle can flow to the needle rollers. TK40715 is a cold-forged, premium strength, solid cross axle u-joint. QU30332 is a hot-forged, cross-drilled u-joint which will physically fit the axle shafts, but since it is cross-drilled, there will be a little loss of strength compared to the original joint.

Tech Note 4: Matching Parts
TK40689 Torque King HD Chrome-Moly Dana 70 Outer Axle Shaft
TK42093 Torque King Chrome-Moly Dana 70 Left Inner Axle Shaft
QA4936 Knuckle Ball Seal Kit
QU40431 Axle Shaft Support Bushing
QK4765 Knuckle Seal Shim Kit
QK4616 Knuckle Bearing and Bushing Kit
QK4618 Knuckle Bearing Kit
QU40367 Dana 70 Diff Cover Gasket

Applications

Dodge:
W300 Dana 70 Closed Knuckle Front Axle: 1958, 1959, 1960, 1961, 1962, 1963, 1964, 1965, 1966, 1967, 1968