TK42047 Chromoly Dana 70 Right Inner Axle Shaft for 1969-1974 Dodge W300

TK42047 Torque King® 1969-1974 Dodge W300 Forged Chrome-Moly Right 35 Spline Inner Axle Shaft is a Heavy-Duty, 1-1/2 x 35 Spline Chromoly, Thru-Hardened Right Inner Axle Shaft for 1969-1974 Dodge 4x4 1 Ton trucks with Dana 70 Closed Knuckle front axles. Length from Center of Hole to end is about 18-1/8". USA Made. NOTE: To use TK42047, you MUST also order optional TK42172 Special Heavy-Duty Spindle Bushing to install in the end of the axle housing in place of your original bushing. TK42047 replaces Dodge 2953838

This shaft is Built to Order therefore your order cannot be canceled once it is placed.

Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your vehicle's repair, maintenance, or upgrade project!

Dan the Gear Man® Tech Notes:
1969-1974 Dodge Tracta Joints
Dodge MUST Replace Assembly
U-Joints
Matching Parts
Applications

Tech Note 1: 1969-1974 Dodge Tracta Joint
To fit through the spindle hole in the knuckle, 1969-1974 Dodge W300 4x4s were factory equipped with relatively weak Tracta type axle shaft assemblies which are out of production. You can replace the Tracta type axle shaft assemblies with our stronger Chromoly Spicer type 1480WJ Axle Shafts similar in design to the factory shafts used in 1961-1975 IHC Dana 70 Axles and 1967-1969 Jeep M715 Dana 60 front axles. The yoke diameter of these shafts is too large to fit through the spindle hole in your knuckle, so to install/remove our axle shaft assemblies, you HAVE to remove the steering knuckle!

Tech Note 2: Dodge-Must Replace Assembly
If you are replacing Tracta Type Axle shafts in 1960-1974 Dodge W300 4x4s, You have to replace the entire shaft which means you are replacing the Inner Shaft, Outer Shaft, and Axle U-Joint.

Tech Note 3: U-Joints
Dana has discontinued the hot-forged, seal-less, solid cross axle shaft u-joints for this application. All our current u-joints have seals which I recommend you remove so lubricant from the knuckle can flow to the needle rollers. TK40715 is a cold-forged, premium strength, solid cross axle u-joint. QU30332 is a hot-forged, cross-drilled u-joint which will physically fit the axle shafts, but since it is cross-drilled, there will be a little loss of strength compared to the original joint.

Tech Note 4: Matching Parts
TK40689 Torque King HD Chrome-Moly Dana 70 Outer Axle Shaft
TK42048 Torque King HD Chome-Moly Dana 70 Left Inner Axle Shaft
QA4936 Knuckle Ball Seal Kit
QU40431 Axle Shaft Support Bushing
QK4765 Knuckle Seal Shim Kit
QK4616 Knuckle Bearing and Bushing Kit
QK4618 Knuckle Bearing Kit
QU40367 Dana 70 Diff Cover Gasket

Applications

Dodge:
W300 Dana 70 Closed Knuckle Front Axle: 1969*, 1970*, 1971*, 1972*, 1973*, 1974*

*See Tech Notes 1 and 2