QU40532 35 Spline Right Inner Axle Shaft for 1985-1988.5 F-350 Dana 60

QU40532 1985-1988.5 Ford F-350 35 Spline Dana 60 Right Inner Axle Shaft is a genuine original equipment part that fits the right side on 1985 to 1988.5 single rear wheel or dual rear wheel Ford F-350 4x4 trucks with Dana 60 Front Axles. Made in U.S.A. or Mexico. The matching outer axle shaft is QU40486.

IF YOU HAVE A 1988-1991 F-350, SEE TECH NOTE 1!

Also See: QU40532U Used 35 Spline Right Inner Axle Shaft available while supplies last

Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your vehicle's repair, maintenance, or upgrade project!

Dan the Gear Man® Tech Notes:
Conflicting Part Numbers 1988-1991
C-Clip Type
Seals
Applications

Tech Note 1: Conflicting Part Numbers 1988-1991
For the Model Years 1988 to 1991, there is conflicting part number information between Dana and Ford parts lists for the Ford F-350 Dana 60 Front Axle. In 1988, Dana shows a mid year model change with axle Bill of Material Number 610313 that effects the axle shafts. My Ford factory Parts Books do not show 610313 axle tag number until 1990 and they still show the parts to be the same as 1985 to early 1988 axles. I can't remember any F-350 that went through the shop that we found the Dana information to be wrong, but truthfully, unless we did not have the correct part in stock, we probably would not compare the Dana and Ford parts data.

Ford F-350 Dana 60 front axles had an inner axle shaft axle length change. Dana lists the new axle shaft as 1988 mid model year change but Ford does not show this change until 1992. If you are looking for an inner axle shaft for a 1988 to 1991 F-350, you will have to verify length. QU40532 is the correct right inner axle shaft if your 1988/91 F-350 right inner axle shaft measures 36.68" from the center of the u-joint hole to the end of the shaft. If your shaft length is 36.97", see QU40526!

Tech Note 2: C-Clip Type
QU40532 takes an internal c-clip type axle universal joint with 1-3/8" diameter cups. The matching axle u-joints are: QU30332 (greaseable hot-forged cross), TK40715 (Premium non-greaseable cold forged cross), and TK40724 (Premium greaseable cold forged cross). For u-joint service tools check out our U-Joint Tools web page.

Tech Note 3: Seals
If you need an axle shaft, chances are you also need the inner axle oil seals located next to the differential. See QU40059 Oil Seal and QK4656 Seal Kit with installation tools.

Applications:
Ford:
F-350: 1985, 1986, 1987, 1988, 1988.5