Description
QU20140 Ford Excursion and Super Duty TYPE A 6 Bellow Front Driveshaft Slip Joint Boot with equal size ends (about 1-3/4" ID each end) is an exact original equipment replacement part for Ford Excursion and 1999, 2000, 2001, 2002, 2003, and 2004 Super Duty® 4x4 Truck with QU40855 Ford Type A Female Spline Slip Yoke. Made in Canada.
Order 2 QU20139 Boot Clamps above to seal and secure this Boot to your driveshaft.
Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your vehicle's repair, maintenance, or upgrade project!
Dan the Gear Man® Tech Notes:
U-Joint Specs
Wear
Applications
Tech Note 1: Clamps
Using a Clamp Tool specifically made to tighten eared clamps around the driveshaft boot is the best way to tension a stainless steel Boot Clamp to provide a 360 air and watertight seal. If a Clamp Tool is not available, you may be able to get by with a nail puller or hoof nippers. Wire cutters could be used in an emergency situation as a last resort, but the results are often unsatisfactory.
Tech Note 2: Wear
A boot protected driveshaft slip joint will usually outlast the truck as as long as the boot is intact and there is some grease on the splines. If your Boot is damaged, REPLACE IT! If your Boot is OK, but you are doing other driveshaft service, always clean and grease the splines AND replace the clamps!
Applications
Ford:
4x4 Excursion
Super Duty with production front CV driveshaft assemblies: 1999, 2000, 2001, 2002, 2003, 2004
Warranty
Product Reviews
-
Ford boot
Hard to find item. Exact same as the worn out old one. Perfect fit.
Delivery & Returns
Shipping times are estimated in your cart.
More info can be found at the link below.