Small Parts 1988-1993 NP231

QK2069 Transfer Case Saver Kit for New Process and New Venture Chain Drive Transfer Cases. Use for all New Process 231 and 241 Transfer Cases with a 2 piece Tailshaft that uses 4 bolts to attach the extension housing to the tailshaft housing. (*See Tech...

QU11016 Detent Poppet Plug is a genuine, original equipment New Process Gear replacement part that fits many New Process and New Venture chain drive transfer cases. Typically, this Plug screws into the front case below the shift cam location. It holds...

QU10923 13 Tooth 38 Spline Speedometer Drive Gear is a genuine original equipment New Process plastic gear for Dodge 1988-1993 NP241D, 1994-1997 NP231DHD, 1994-1997 NP241DLD NPG Transfer Cases. Also fits 1994-1996 Dodge NP241DHD transfer cases with the...

QU10987 Range Fork Rail Bushing is a genuine New Process original equipment part for 1980's to early 1990's New Process NP231 and NP241 Transfer Cases. QU10987 fits 1989-1991 Chevy or GMC NP241C right hand drop models in Blazers, Jimmys and V1500/V2500...

QU50296 NP231 Basic Transfer Case Small Parts Kit fits most Chevy, Dodge, GMC, and Jeep New Process NP231 series Transfer Cases. Kit includes Shift Fork Pads, Snap Rings, ans planetary Thrust Washers. Note: Most mid 1990's and newer NP231 Transfer Cases...

QU11312 Rear Output Bearing To 27 Spline Rear Output Shaft Snap Ring for New Process NP207, NP231, and NP233 transfer cases.

QU70016 Internal Type Snap Ring for 1-3/8" OD Groove in Splined Transfer Case Couplers and similar applications. Free Diameter is 1.526".

QU10948 Front Output Yoke Nut for the front output shafts on New Process NP231 series and other similar transfer cases with metric output shafts in Chevy, Dodge, GMC, and Jeep 4x4's.

QU50803U Used Mode Synchronizer Strut/Key for New Process and New Venture, NP207, NP208, NP231, NP233, 48T NP241 (except NP241DHD), NP243, NP261, NP263, and NP273 transfer cases.

QU11016U Used Detent Poppet Plug fits many New Process and New Venture chain drive transfer cases. Typically, this Plug screws into the front case below the shift cam location. It holds QU11027 Poppet Spring and QU11018 Poppet Plunger...

QU11018U USED Poppet Plunger is a genuine New Process gear replacement part that fits many New Process and New Venture chain drive transfer case models. Not a common part to fail, but when the tip wears, the transfer case will have a tendency to jump...

QU10674U USED Transfer Case Oil Pickup Screen for left drop New Process Transfer Cases. Your Oil Screen is located in the bottom of the case just above the chip magnet. The plastic screen filters out chips and crud from the oil before it gets to the...