New Venture NV4500 Manual Transmission Tools

QT1801 82mm to 3-1/4" OD Transmission, Pinion, Front or Rear Wheel Bearing Cup Installer is used to install many of the Bearing Cups used in Chevy, Dodge, Ford, GMC, and Jeep full sized SUV's, 1/2, 3/4 and 1-ton trucks from 1968 to current. QT1801 fits...

QT2002 NV4500LD Mainshaft Nut Wrench QuadTool™ is a necessity to remove or install the mainshaft nut. Required for all in-vehicle and bench repairs that involve mainshaft service, including mainshaft fifth gear replacement. Fits Dodge Gas 6/V8...

QT2000 29 Spline Mainshaft Holding Socket Wrench by QuadTool™ is a USA Made, 1/2" drive steel 29 spline wrench used for keeping the mainshaft from rotating when removing or installing the mainshaft nut in the vehicle. Fits Dodge NV4500/4500HD...

QT1101 14" Standard Duty Installer Driver Handle with knurled hand grip are used with QT1500 series Seal Installers and QT1800 series Bearing Cup Installers with 5/8'" center holes. 1" diameter x 14" usable length for deep seated seals and bearings...

TM1004 NV4500 Exploded View and Parts Guide is High Quality, full color printing on 8-1/2" wide x 11" high paper. Has plastic covers and will open flat so you can have the manual right next to you as you compare your parts! For all New Venture 5 speed...

QT2044 Rear Output Bushing Remover and Installer is a low cost, CNC machined steel tool made to quickly and easily remove and install the QU10025 1999-2005 4x2 Dodge NV4500HD/NV5600 Manual Transmission and QU90025 1996-2002 Dodge NP241DHD 4x4 Transfer...

QT2036 Heavy-Duty 3/4" Drive Mainshaft Nut Wrench QuadTool™ is a necessity to remove or install the mainshaft nut. Required for all in-vehicle and bench repairs that involve mainshaft service, including mainshaft fifth gear replacement. Fits all...

QT1802 Bearing Cup Installer is specifically machined to fit QU10142, QU10145, QU50447, QU50629, and QU50653 bearing cups commonly used in axle, transmission and wheel applications. Precision CNC machined solid steel tool is drilled to accept any...

QT9300 3/16" x 8" Punch has the extra long shank required to remove NV4500 transmission shift fork roll pins and other hard to reach applications.

QT2028 GM 4x4 Output Shaft Nut Socket removes/installs the mainshaft nut on all GM 4500's with or without a vibration dampener. 3/4" Drive. Required for all mainshaft related repairs when the transmission is equipped with a vibration dampener (mainly...

QT9205 Torx® Socket Bit for NV4500HD Output Shaft Nut and Ford Super Duty Hub-Locks 1/4” drive socket is used to adjust the lock bolt in the Original Equipment split output shaft nut on 1998 and newer Dodge NV4500HD transmissions. Also used to...

QT1179 Economy Bearing Cup Remover Punch is specifically made for the Do-it Yourself mechanic that needs a good, functional, yet lower cost Bearing Cup Removal Punch for occasional use. Our USA Made QT1179 is about 14" long making it long enough to...