QU50666 0.100" Thick 32 Spline Rubber Yoke Seal

QU50666 0.100" Thick 32 Spline Rubber Yoke Seal for 32 Spline Front Output CV Flange Yokes is approximately 0.100" thick with 32 splines and is the best fit for most NP205 and NP208 32 spline front output shafts with CV flanges or yokes that use a one piece nut and washer. Genuine NPG part. USA Made.

Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your vehicle's repair, maintenance, or upgrade project!

Dan the Gear Man® Tech Notes:
Thickness
Wear
Applications

Tech Note 1: Thickness
New Process lists TK10513 0.182" thick Spline Seal for all 32 spline NP205 front output applications. However, we have found this 0.182" Seal is too thick for most CV front output flanges and yokes that are retained by the factory flanged nut (QU10512). Friction from the nut as it is tightened will often cause the Spline Seal to get squeezed between the nut and CV flange/yoke instead of compressing into the yoke. We have found two stacked QU50666 0.070"-0.075" thick seals shown here or one 0.130"-0.140" thick TK10513 Spline Seal will compress into the yoke bore without being squeezed out. QU50666 is the OEM spline seal for some NP208 front output flanges.

Tech Note 2: Wear
Sometimes the NP205 front output bearing will wear into the inboard face of your front output flange. If your yoke is worn this way, you may only need one QU50666 Seal. Try two first, if the outer seal gets sucked between the nut and flange, remove it and just run one seal.

Applications
New Process NP205 and NP208 Transfer Cases with 32 Spline Front Output CV Flange Yokes