Full Time Drive Gears 1980-1996 Ford Dana 44IFS

QU40050 Spicer Tapered Hub Spring for SUV's, and pickups with Dana Spicer Model 30, Model 44 or GM 10 Bolt front drive axles equipped with internal mount, Spicer lock out hubs or full time drive gears. These springs were used on most of the late 1960's...

QU40035 Hub Spring Plate or Spring Cup for Splined 4x4 Wheel Hubs fits between the QU40050 hub spring and the outer wheel bearing cup on SUV's, and pickups with Dana Spicer Model 30, Model 44 or GM 10 Bolt front drive axles equipped with internal mount,...

QU40427 GM 10 Bolt and Dana 44 Full Time Front End Hub Cap is a genuine Dana replacement part for 1959-1993 Chevy, Dodge, Ford, GMC, and Jeep 4x4 SUVs and trucks with Dana 44 or GM 10 bolt front axles. These steel Caps are the redesigned cap that was...

QU40614 Inverted Lug Outer Axle Shaft Snap Ring is a genuine original equipment Dana part for 1970's to mid 1990's Chevy, Dodge, Ford, GMC, International, and Jeep 4x4s with 19 Spline Outer Axle Shafts. One of these snap rings is used on each outer axle...

QU40035U USED Hub Spring Plate fits between the QU40050 hub spring and the outer wheel bearing cup on SUV's, and pickups with Dana Spicer Model 30, Model 44 or GM 10 Bolt front drive axles equipped with internal mount, Spicer factory lock out hubs...

QU40050U Good USED Spicer Tapered Hub Spring QU40050 Spicer Tapered Hub Spring for SUV's, and pickups with Dana Spicer Model 30, Model 44 or GM 10 Bolt front drive axles equipped with internal mount, Spicer lock out hubs or full time drive gears. These...

QU40427U USED GM 10 Bolt and Dana 44 Full Time Front End Hub Cap for 1959-1993 Chevy, Dodge, Ford, GMC, and Jeep 4x4 SUVs and trucks with Dana 44 or GM 10 bolt front axles. These chromed steel Caps are the redesigned cap that was introduced in the 1980's...

QU40428U Used 7/8" Wide Single Width Gear for Dana 30, Dana 44, and GM 10 Bolt Front Axles. QU40428 has full length ID and OD splines. These gears have 2 to 10 holes in them to reduce the weight and provide a way to remove them with a hook. QU40428...

QU40657U Used 7/8" Wide Stepped Gear for Dana 30, Dana 44, and GM 10 Bolt Front Axles. QU40657 was the most common type splined hub gear from the the late 1970's to the late 1980s. Outside spline that engages wheel hub is a little under 5/8" wide. These...

QU40598U Used 1-1/4" Wide Stepped Gear for Dana 30, Dana 44, and GM 10 Bolt Front Axles. QU40598 was the original design. Outside spline that engages wheel hub is 27/32" wide. These gears are stepped on the outboard side to aid in removal and to space...

QU40598 1-1/4" Wide Stepped Gear for Dana 30, Dana 44, and GM 10 Bolt Front Axles. QU40598 was the original design. Outside spline that engages wheel hub is 27/32" wide. These gears are stepped on the outboard side to aid in removal and to space the gear...