All 4x4 Truck Parts & Truck Tools

QU20155 Ford 9 Tooth Speedometer Drive Gear for 1973-1979 F100, F150, and F250 trucks with a 3 speed manual transmission.

QU20159 Threaded Clutch Fork Pivot Stud for 1983-1997 Ford F-Series and Bronco with external clutch slave cylinder and threaded pivot stud.

QU20180U USED 1980 to 1997 Ford Bronco, F150, F250 Dana 44IFS, Dana 50IFS Front Axle Pinion Yoke for 1980 to 1996 Ford Full Size Bronco, F-150 and 1980-1997 Ford F-250 4x4s. This Pinion Yoke fits both Dana 44 IFS and Dana 50 IFS (IFS=Independent Front...

QU20188 1999-early 2007 Ford New Process NV273F Electric Shift Transfer Case Front Case Half is a genuine New Process replacement sub-assembly that includes QU50250 input bearing, QU10906 front output bearing, and the planetary annulus ring. Case casting...

QU20189U Used 1999-2004 Rear Extension Housing with Full Complement Needle Bearing for 2000-2004 Ford Excursion and 1999-2004 Ford Super Duty® F-250, F-350, F-450, F-550 4x4 trucks with either NV271F Manual Shift or NV273F Electric Shift Transfer...

QU20197U Used Front Output Flange for 2006-2010 NV271F, NV273F Ford Super Duty New Venture Transfer Cases. Available while supplies last. Also see QU20197 new.

QU20230 5 Pleat Slip Joint Boot for 1986-1997 1-3/8" x 32 spline Ford front and rear driveshaft slip stubs. Matching slip yokes are 30 based on 32 spline or 31 based on 32 spline. Need More Info? Use the handy Links below to access over 40 years of...

QU20236U Used 3.73 Ratio Dana 50 Ring and Pinion Set is a brand new Dana 3.73 ratio gear set. 3.73 ratio Dana 50 axles were made from 1999-2005. Ring gear tooth count is 41, pinion gear tooth count is 11. Available while supplies last. Also...

QU20246U-2 Used Differential Bearing Caps for Ford Dana 50 Axles Differential Bearing Caps are line bored for each axle and considered non-interchangeable. However, if you do not have a differential case spreader, you can use an extra pair of caps to...

QU20253U Good Used Hub Cam Lock Ring fits in groove in QU40406 Hub Cam. See QU20253 for New Hub Cam Lock Ring

QU20271U Good Used Differential Case Dana Model 60 is a genuine Dana-Spicer part. QU20271U fits many Dana-Spicer Model 60 front or rear axles with open differentials and 4.30 or numerically lower gear ratios (ex: 3.54). Also fits 3.07 ratio Dodge Dana...

QU20272U Used Dana 60 Internal Diff Kit is a good used 35 spline "spider gear" set taken from axle assemblies our Research and Development Department had for part verification and tool design purposes. It includes the 4 gears, 4 thrust washers, and cross...