Filters
10 products
Shop now for Spindle Parts to fit 1941-1964 Jeep CJ-2, CJ-2A, CJ-3A, CJ-3B, Willys MB, Willys M38, and Ford GPW with either Dana-Spicer Model 25 or Dana 27 closed knuckle front axles.
Spindle Nuts: 1945-1964 Jeep CJs with manual lock-out hubs or solid drive flanges use the same four piece spindle nut parts as the World War II military MA and MB Jeeps. A thrust washer is used between the outer wheel bearing and inner spindle nut. The inner nut adjusts the wheel bearing end-play. The outer nut functions as a lock nut, it is held in place by a bend-over lock washer located between the two nuts. Vehicles with Warn Lock-O-Matic Hubs require special lockwashers and round outer nuts.
Spindle Bushings: One of these QU40321 Bushings are pressed into the inboard side of each spindle to support your outer axle shaft. These are one of the most common 1941-1971 Jeep Dana 25/Dana 27 closed knuckle front end parts requiring replacement as both the thrust face and inside diameter of the Bushing are subject to wear.
