Filters
27 products
Shop now for Spindles, Spindle Nuts, Spindle Bearings, and Spindle Seals to fit 1994-2002 Dodge Ram 2500 trucks with Dana 70 Rear Axles. Great selection. In stock. Quick shipping.
Dodge use the same QU40293D front spindle on all 1975 to 1993 4x4 trucks with the Model 60 or 61 open knuckle front drive axle. Spindle nuts are a different story. Dodge used a 2-9/16" hex nut with a bend over tab lock washer from 1975 to 1991. For 1992 and 1993, a round 4 slot nut double nut design was used. It is not uncommon to find the newer nuts set used on the older trucks or vice a versa. We used to see this a lot on fleet trucks where the nut styles were apparently changed for standardization reasons.
The dead spindle design of the 1975-1993 era Dodge Dana 60 series axles uses QU40149 needle bearing to support QU40330D outer axle shaft. To protect the bearing and control axial thrust, a 4 piece set consisting of QU40064 Slinger, QU40065 Large V-Seal, QU40148 Small V-Seal, and QU40066 Thrust Washer was used. We have both Kits and individual exact replacement Dana-Spicer Spindle small parts for your hard-working Dodge.
