Description
QK1017 Complete Filter and Double Cooler Kit with G56 Hardware for 6 speed 4x4 and 3/4 ton to 1-1/2 ton Truck Manual Transmissions has both a cooler for one side and a combination filter and cooler for the other side of your transmission, each of which bolts in place of one of your PTO Covers. Protect your investment and extend the life of your gear boxes by cooling AND cleaning your oil! As part of one of the Coolers, this kit includes a simple, but astonishing effective, splash feed filter, that constantly cleanses your Transfer Case or Manual Transmission oil of both magnetic and non-magnetic particles. Fits all makes of manual transmissions and transfer cases with two standard 6 bolt PTO covers! Most of these manual transmission models were available with either 1 or 2 PTO Mounting locations depending upon the vehicle configuration. Before ordering this Kit, make sure YOUR transmission has a 6 Bolt PTO cover on each side!
Note: Dodge/Ram Getrag G360 5 speed and G56 6 speed transmissions use 10mm metric bolts which are supplied in this Kit!
Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your vehicle's repair, maintenance, or upgrade project!
Dan the Gear Man® Tech Notes:
Deburred Housings
Cooler
Filter
Increased Oil Capacity
Clearance to Other Components
Kit Includes
Other Available Kits
Matching Parts
Applications
Tech Note 1: Deburred Housings
As supplied to us, the extruded aluminum Filter Housings have some sharp edges and/or burrs that can cut skin. We deburr each and every housing to minimize the chances of cuts.
Tech Note 2: Cooler
The fins on the extruded aluminum cooler housing greatly increases the surface area available that conducts heat from the oil to the air. Our Coolers can reduce your transmission oil operating temperature by up to 30° which is especially beneficial for 5 and 6 transmissions operated in overdrive. In direct drive, (4th for a 5 speed or 5th for a 6 speed) the power transfer is efficient and direct from the input shaft to the output shaft with no loads placed on the gear teeth or countershaft bearings. In overdrive, the power transfer from the input to the output is through the countershaft which means 4 gears and 6 bearings are under load and creating additional heat that can breakdown your transmission fluid. In the QK1017 Kit, one housing supplied with both a 3/8" filler Plug and a 1/4" drain plug that can be replaced by a temperature sending unit.
Tech Note 3: Filter
Most manual transmissions have no way to filter grit and wear particles from the oil. This means damaging contaminants in your oil will be constantly run through your bearings and gears which of course means even more junk in the oil and the ugly and expensive specter of early, catastrophic part failures. The QK1015 Filter can be installed on any manual transmission or transfer case with a standard SAE 6 Bolt Power Take Off Cover Plate on one or both sides of the gear case (The PTO Covers are often mistaken for an "Inspection Plate"). QK1015 fits popular transmissions like Borg Warner T18, T19, and T98 4 speeds, Dodge G56 6 Speed (use QK1017 instead of QK1015), Muncie SM420 and SM465 4 Speeds, New Process NP435 4 Speed, New Venture NV4500 5 Speed, New Venture NV5600 6 Speed, ZFS5-420 and S5-470 5 Speeds and ZF 6 Speed light truck transmissions. QK1015 also fits NP205 and NP241DHD transfer cases along with Borg Warner chain drive transfer cases with PTO covers. The QK1015 works because of the movement of oil inside a transmission or transfer case. Oil in a gearbox is in constant, high-speed, motion when the vehicle is in operation. If you ever had the top cover off a transmission and absent mindlessly started the engine with a remote starter switch, you have seen how much and how fast the oil gets thrown about. When a QK1015 Filter is installed on your transmission or transfer case, and you are running at highway speeds, oil is thrown into the QK1015 inlet at high speed and with tremendous volume. It does not take long for crud in your oil to get trapped in the filter. Even at an idle, oil is constantly flowing through the filter element. In summary, The QK1015 Manual Transmission and Transfer Case Filter Kit is effective and...... a whole lot cheaper than gears and bearings!
Tech Note 4: Increased Oil Capacity
Each Filter or Cooler/Filter will increase your transmission oil capacity by approximately 1 quart. To help monitor your transmission oil level, one of the 1/4" thick outer plates is equipped with a rugged sight glass.
Tech Note 5: Clearance to Other Components
You have to have sufficient clearance around the transmission PTO openings to install the filters. Each Aluminum Housing is 3" wide. The plain outside Cover Plate is 1/4" thick. Maximum Thickness of the Cover Plate with Sight Glass is about 3/4". The inside Filter Plate is 5/64" thick.
Including the nuts and bolts which add about 3/8", the minimum clearances typically needed to install are:
Cooler with Filter and Plain Cover Plate: 4-1/4"
Cooler with Sight Glass: 4-1/2"
If you don't have enough room to install the tall 3" wide coolers, use QK1014 Slim 1-7/8" Double Cooler Kit instead
Tech Note 6: Kit Includes
QU52124 Finned Cooler Housing with 3/8" NPT Fill Plug and 1/4" NPT Drain plug (NPT=National Pipe Thread)
QU52125 Plain Finned Cooler Housing (No Plugs)
QU52126 Outer Cover Plate with Sight Glass
QU52127 Plain Outer Cover
QU52128 Inner Filter Plate
QU52129 Replaceable Filter Element
12 QU52134 Metric Bolts for G56
2 QU52135 G56 Shims
QU90006 3.35 oz Ultra Black RTV Sealant
Instructions
Tech Note 7: Other Available Kits
QK1013 Slim 1-7/8" Wide Double Coolers Only with Hardware Kit
QK1014 Slim 1-7/8" Wide Complete Filter and Double Cooler Kit
QK1015 Complete Double Cooler and Filter Kit
QK1016 Double Cooler Kit (no filter parts)
QK1017 Complete Dodge/Ram Getrag G360 5 speed and G56 6 speed transmissions with 10mm metric bolts
QK1018 Double Cooler Kit Dodge/Ram Getrag G360 5 speed and G56 6 speed transmission with 10mm metric bolts (no filter parts)
QK1019 Double Coolers Only with Hardware Kit
QK1020 Cooler Cover Kit, 1 with sight glass, 1 without
QK1021 Cooler Filter Kit. 1 Filter, 1 Filter Adapter
QK1022 Standard Bolt with Washers Kit
QK1023 Metric Bolt Kit with 2 G56 Shims
QK1026 Complete 1 Side Cooler Filter Kit
QK1038 Slim 1-7/8" Complete 1 Side Cooler Filter Kit
QK1042 Complete 1 Side Cooler Filter Kit for Dodge/Ram Getrag G360 5 speed and G56 6 speed transmission with 10mm metric bolts
Tech Note 8: Matching Parts
QU52129 Filter Element
QU90020 75w85 NV4500 Manual Transmission Fluid
SM1QT Synchromesh NV5600 Manual Transmission Fluid
Applications
Dodge/Ram Getrag G360 5 speed and G56 6 speed transmissions
Warranty
Product Reviews
-
QK1017
Excellent product to keep my Getrag 360 cool.
-
G56 cooler kit with filter
Well made kit with magnetic plug, site glass and filter. Filled to level with the fill hole in the transmission and the site glass is at 3/4. Took approximately 2 gallons of 50 wt. Delvac.
Delivery & Returns
Shipping times are estimated in your cart.
More info can be found at the link below.
