QU50048 Crimp Hose Clamp for Most 5/16" ID hoses

QU50048 Clamp for Axle Vent Hose This original equipment type, stainless steel, 1-ear clamp is used to secure standard, 5/16" inside diameter axle vent hoses on many Dana-Spicer and corporate front and rear axles plus numerous transmission and transfer case applications. Maximum outside diameter of hose can not exceed 9/16". Made in Canada.

Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your vehicle's repair, maintenance, or upgrade project!

Dan the Gear Man® Tech Notes:
Inspect
California
Matching Parts
Applications

Tech Note 1: Inspect
Do you have an axle, transfer case, or transmission seal leaking? If so, check the vent fitting, hose, and end cap for obstructions. As you drive and heat builds up from friction, a plugged vent system will prevent expanding gases from exiting to the atmosphere. Result: Leaks occur as pressure builds up and forces lubricants past the seal.

Tech Note 2: California
WARNING: This product contains Nickel, a chemical known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov

Tech Note 3: Matching Parts
QU10924 5/16" Hose
QT4018i Ear Type Boot Clamp Pliers
Interactive Exploded View XV1010DT 1995, 1996, 1997 Ford F250 Dana 50IFS Axle

Applications
Specific applications for this part are too numerous to mention.