Description
QU40884 Small Driveshaft Boot Clamp is a one-ear, crimp type stainless steel Boot Clamp for the small (Slip Stub) end of slip joint boots used on Ford Excursion and 1999-current Ford Super Duty rear driveshafts with QU40883 3-Pleat rear slip joint boots. Made in Canada or U.S.A.
Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your vehicle's repair, maintenance, or upgrade project!
Dan the Gear Man® Tech Notes:
Inspect Boot
Tools
Applications
Tech Note 1: Inspect Boot
A boot protected driveshaft slip joint will usually outlast the truck as long as the boot is intact and there is some grease on the splines. If your Boot is damaged, REPLACE IT! If your Boot is OK, but you are doing other driveshaft service, always clean and grease the splines AND replace the clamps!
Tech Note 2: Tools
Using a Clamp Tool specifically made to tighten eared clamps around the driveshaft boot is the best way to tension a stainless steel Boot Clamp to provide an air and watertight seal. If a Clamp Tool is not available, you may be able to get by with a nail puller or hoof nippers. Wire cutters could be used in an emergency situation as a last resort, but the results are often unsatisfactory.
Applications
Ford:
Excursion Rear Driveshafts with 3 Pleat Rear Slip Joint Boots
Super Duty Rear Driveshafts with 3 Pleat Rear Slip Joint Boots: 1999-current
Warranty
Product Reviews
-
5
Perfect fit and good quality clamp.
Delivery & Returns
Shipping times are estimated in your cart.
More info can be found at the link below.
