Description
QU30035 GM 10 Bolt Pinion Preload Crush Sleeve fits all 1977-1991 full size Chevy and GMC 4x4s with GM 10 Bolt front axles. Also fits GM 10 Bolt 8-1/2" Ring Gear Rear Axles.
Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your vehicle's repair, maintenance, or upgrade project!
Dan the Gear Man® Tech Notes:
Installing
Tech Note 1: Installing
The initial overall length of this spacer is greater than the normal separation distance between the two pinion bearings. As you tighten your pinion nut against the yoke, you will push the outer bearing against this Spacer. At that point the nut will seem tight but your pinion will still be loose. You now must increase the torque applied to the nut by a substantial margin to initiate the compression of the spacer. Once it starts to compress, the required torque needed to continue tightening the nut will still be high, but reduced from the amount needed to start compression. As the Spacer collapses, your pinion end play will gradually disappear. When all end-play is gone, you have to be very careful as it will only take a small movement of the nut to go from too loose to too tight. If you over tighten the nut, you MUST get a new spacer and start over!!! Never back off the nut to try and reduce the rotating preload of the pinion!!!! See the factory shop manual for your truck for rotating preload specs.
Warranty
Product Reviews
Delivery & Returns
Shipping times are estimated in your cart.
More info can be found at the link below.