QU20085 3 Piece, 30 Spline Axle Shaft Thrust Washer Ford Dana 50IFS, 60

QU20085 Three Piece, 30 Spline Ford Dana 50IFS, Dana 60 Axle Shaft Thrust Washer Set for 1993 to 1997 Ford F-250 with Dana 50 front axles and 1992-1997 Ford F-350 with Dana 60 front axles. This Thrust Washer Set is used on outer axles shafts with snap ring grooves on the inboard end of the splines. The Thrust Washers fit between the end of the spindle and the axle shaft snap ring. Order two Kits per vehicle. Extremely Limited Supply!

Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your vehicle's repair, maintenance, or upgrade project!

Dan the Gear Man® Tech Notes:
Before Using
Hub Type
Before Installing Hubs
Matching Parts
Applications

Tech Note 1: Before Using
Only use this Thrust Washer Set if your truck was originally equipped with similar parts.

Tech Note 2: Hub Type
These 3 Piece Thrust Washer Sets were primarily used on trucks equipped with factory lockout hubs that use either 3 or 5 screws to retain the hub lock cap. If you are wanting to use this set with Warn factory type manual hubs with 6 screw in the cap or an aftermarket hub set, you MUST insure there is enough clearance between the axle shaft snap ring and your new inner hub body.

Tech Note 3: Before Installing Hubs
Grease the faces of all three pieces before installation. Install the three Thrust Washers in this order: (1) Plain Steel Washer against the Spindle, (2) Plastic Washer in Middle, (3) Splined Washer next to Snap Ring.

Tech Note 4: Matching Parts
Interactive Exploded View XV1010DT 1995, 1996, 1997 Ford F250 Dana 50IFS Axle
QU20208 Axle Shaft Snap Ring for Auto Hubs
QU40155 Axle Shaft Snap Ring for Manual Hubs
QU20227 Dana 50IFS Spindle for F-250
QU40420 Dana 60 Spindle for F-350
QK4773 Left Axle Shaft for F-250
QK4774 Right Axle Shaft for F-250
QU20079 Outer Axle Shaft for F250
QU40371 Outer Axle Shaft for F-350
QU20087 Auto Hub Service Kit for 1995-1997 Ford F250, F350
Ford Shop Manuals

Applications:
Ford:
F250 with Dana 50IFS Front Axle and Factory Lockout Hubs using 3 or 5 Cap Screws: 1993, 1994, 1995, 1996, 1997
F350 with Factory Lockout Hubs using 3 or 5 Cap Screws: 1992, 1993, 1994, 1995, 1996, 1997