All 4x4 Truck Parts & Truck Tools

QU40662 Slow Ratio 35 Spline Dana 60, Super 60 Loaded Differential Case Kit has 100% genuine Dana-Spicer parts. These 35 spline open differentials are complete with factory installed "Spider Gear" set, differential bearings, ring gear bolts, and...

QU40676U Good Used 3.07 Ratio Dana 44 Ring and Pinion Set for standard rotation Dana 44 axles. Pinion shaft has 26 splines. Tooth count 43-14. Available while supplies last.

QU40693U Used, Weathered but Useable, Yellow Plastic Hub Dial for 1972-1978 GM Dana 44 or 10 Bolt front axles with 1st Design Spicer factory lockout hubs. Available while supplies last.

QU40707U Used 1350 Series Pinion Yoke for GM 10 Bolt 8.5" Front or Rear Axles that use 1-5/16" I.D. Seals. U-Joint cup diameter is 1-3/16", U-Joint width is 3-5/8". Available while supplies last. Also See: QU40707 New 1350 Series Pinion Yoke

QU40714 1410 Series Pinion Yoke for Dana Model 60 and 70 Axles is a genuine Dana Spicer original equipment replacement part for most trucks and vans with Dana 60, 61, or 70 rear drive axles. Includes a U-shaped slinger that fits over protruding lip on...

QU40783 1310 Series EZ-Grease D1310 Series External Snap Ring U-Joint with cup type lube fitting for double cardan CV joints.

QU40850B New Closeout Blemished 1330 Ford Yoke with some light surface rust 1980 to 1997 Ford Bronco, F150, F250 Dana 44IFS, Dana 50IFS Front Axle Pinion Yoke is a genuine original equipment Dana 26 Spline Front Pinion Yoke with Slinger for 1980 to 1996...

QU40860 Unfinished Greaseable Brand New Front CV Shaft Assembly for Ford Replace your worn out Double Cardan Constant Velocity 2000-2005 Ford Excursion or 1999-2016 Super Duty 4x4 front CV driveshaft with a brand new, totally greaseable, USA made Double...

QU40861 Unfinished Greaseable Rear CV Drive Shaft Assembly for 1999-2004 Ford Super Duty is the lowest cost way to replace your worn out Double Cardan Constant Velocity Ford Super Duty rear driveshaft with a brand new, totally greaseable, heavy duty...

QU40901 1350 Series Greaseable Ball Stud Tube Yoke for 3.5" diameter tube, 0.083" tube wall thickness, Double-Cardan Constant-Velocity front or rear driveshafts made for Spicer 1350 Series universal joints with a cup diameter of 1-3/16"...

QU40907 Press-On Type, Splined Driveshaft Slip Yoke Seal fits 16 spline slip yokes made for press-on seals mated to 1-3/8 x 16 spline slip stubs with full length splines. Need More Info? Use the handy Links below to access over 40 years of Dan's...

QU40922U Used 19 Spline Outer Dana 44 Front Axle Shaft for all 1976-1977.5 Ford F250 4x4s with disc brake equipped Dana 44 Open Knuckle Front Axles. Available while supplies last. Need More Info? Use the handy Links below to access over 40 years of...