4x4 Front Inner Axle Seal Remover Tool Sets for Chevy, Dodge, Ford, GMC, IHC, Jeep, Ram

Our Front Inner Axle Seal Remover Tool Sets can be used for many common front inner axle oil seals is a real time saver & makes your job lots easier! Use to remove the inner axle shaft oil seals on any 4x4 solid front drive axle with axle housing tube inside diameters of 1-3/4" or larger and axle shaft seal inside diameters of 1-1/2" or smaller. This handy tool knocks out those tricky inner axle shaft seals in a flash! In addition, the QK4647 Tool Set lets you easily remove the 1-9/16" ID oil bath type front axle shaft oil seals on 1999-2004 Ford Super Duty and 2000-2005 Ford Excursion 4x4s without removing or damaging the fragile plastic axle tube guides! Space saving, two piece rod, threads together for removing the long side seal. Use just the long rod for knocking out the short side seal. For axles with axle tube inside diameters of under 1-3/4", use the nut as your remover tip.

Often we sell the QK4647 Remover Tool Set for the 1999-2005 Fords that includes the QT1144 Attachment, but now we have 2 additional Tool Attachments for this Remover Tool Set so you can swap them out to work on other vehicle makes and models! QT1214 Attachment, and QT1216 Attachment are available in Tool Sets or separately to add to your Front Inner Axle Seal Remover Tool Set collection!

QT1144 available separately or in QK4647 fits axle tube inside diameters of 1.75" and larger. Max seal ID with rubber lip seals is 1.5", max seal diameter with oil bath type seal is 1-9/16" (used on Ford Excursion and Super Duty® Model 50 and 60 monobeam axles from 1999 to 2004). This remover fits most Model 30, Model 44, and GM 10 Bolt front axles. The outside diameter is made to fit through the inner plastic axle guides used on 1999-2004 Ford Super Duty and 2000-2005 Ford Excursion.

QT1214 available separately or in TS1184 fits axle tube inside diameters of 2.00" and larger. Max seal ID 1-3/4". This remover fits most Model Model 44, Model 50, Model 60, Model 61, Model Super 60, Model 70, AAM 925, and GM 10 Bolt front axles with 3" or larger outside diameter axle tubes.

QT1216 available separately or in TS4862 fits axle tube inside diameters of 2.25" and larger. Max seal ID 2". This remover is primarily made to remove the large bore, right side seal on 2000-2002 Dodge Ram 2500 and Ram 3500 trucks with vacuum controlled Central Axle Disconnect (CAD). It will also work on all to remove the left seals on the same model trucks, plus either seal on all 2002 and newer Dodge Ram 2500 and Ram 3500 models and all 2005 and newer Ford Super Duty® F-250, F-350, F450, and F-550, 4x4s.

For Smaller Axles: For axle tube diameters between 1.50" and 1.75", you just use QU95008 nut as the remover.