QT1511 Rear Wheel Seal Installer for Vintage Dodge and Jeep Dana 60s

QT1511 Rear Wheel Seal Installer installs QU50892 Wheel Seal in 1972-1976 D200, W200, B300, P200, CB300 Dana 60 Rear Axle with Single Rear Wheels. Also fits Jeep Dana 60 full-floating Rear Axles prior to 1974. Fits Seals for 2-5/8" shaft size. QT1511 is specifically made to quickly and safely install QU50892 Wheel Seals in the back of your vintage Dodge or Jeep truck rear hub. Simply place your Seal on the Tool's pilot, attach a QT1100 series driver handle and drive the seal into place. The Installer will stop when the seal is square to the bore and seated to the correct depth. A relief groove in the installer allow adequate clearance for the outer seal lip, thereby preventing one of the most common causes of premature seal failure. Aluminum Installer is Made in U.S.A. by us here in Roberts, Montana.

Need More Info? Use the handy Links below to access over 40 years of Dan's product and vehicle specific Tech Notes to easily get the information you need for your vehicle's repair, maintenance, or upgrade project!

Dan the Gear Man® Tech Notes:
After Installing 
Applications

Tech Note 1: After Installing 
After the seal is installed, lubricate the seal lips with clean wheel bearing grease.

Applications: 

Dodge Dana 60 Standard Duty Axle with 1-13/16" Spindle Thread
5500 pound rated, single rear wheel Dodge Dana 60 rear axles in D200 and W200 trucks with spindle thread size 1-13/16": 1972, 1973, 1974, 1975, 1976
5500 pound rated, single rear wheel Dodge Dana 60 rear axles in P200, P300, B300 vans and van based motorhome chassis with spindle thread size 1-13/16": 1972, 1973, 1974, 1975, 1976

Jeep
3/4 ton SRW with full floating Dana 60 Rear Axle and 8000 pound GVW and/or 3407 Build Code: 1967, 1968, 1969, 1970, 1971, 1972, 1973